Home > Products > DMX Constant Current Drive

Products - DMX 3-Channel Constant Current drive unit, 350mA / 700mA selectable

green

Key Features:

  • Comply with USITT-DMX512-A DMX protocol standard
  • Connect up to 120 drivers in one DMX control signal loop
  • In-built end-of-line terminal resistor (120 ohm) selectable via DIP switch setting
  • No restart of driver needed after any DMX address changes
  • Test mode for output LED connection
  • Status display for DMX signal, RGB output status & test mode
  • 350mA or 700mA constant current outputs for each channel via dip switch on circuit board
  • Wide input voltage range from 6Vdc to 48Vdc

Model No:

  • DMX-0350-0700SEL-CPWMD

General:

  • USITT-DMX512-A DMX protocol standard
  • DMX PWM frequency – 200Hz, constant current switching frequency – 254kHz
  • Wide input voltage range of 6Vdc to 48Vdc
  • Allow up to 120 drivers to be connected in one single DMX line
  • Operating temperature range from 0°C to 50°C, with a maximum temperature of 65°C
  • Power Dissipation (loss):   0.45 watt (idle)   – no load
    @Vin 30Vdc, 25°C      1.85 watt (typical) – typical façade load
                 6.05 watt (max)  – full load

Physical:

  • Dimension:  180mm (L) x 43mm (W) x 28mm (H)
  • Weight:   approx. 210 g

Interface:

  • 2 x screw terminal for Power in - 6Vdc to 48Vdc (12 - 22 AWG)
  • 4 x screw terminal for LED fixture output (12 - 22 AWG)
  • 3 x screw terminal for DMX in (12 - 22 AWG)
  • 3 x screw terminal for DMX out (12 - 22 AWG)

Certifications:

  • CE compliant - Pending

© 2013 DAS Integrator Pte Ltd (Singapore). All Rights Reserved.