DMX 3-Channel Constant Current drive unit - 500mA / 1000mA selectable
Key Features:
- Comply to USITT-DMX512-A DMX protocol standard
- Connect up to 120 drivers in one DMX control signal loop
- In-built end-of-line terminal resistor (120 ohm) selectable via DIP switch setting
- No restart of driver needed after any DMX address changes
- Test mode for output LED connection
- Status display for DMX signal, RGB output status & test mode
- 500mA or 1000mA constant current outputs for each channel via dip switch on circuit board
- Wide input voltage range from 6Vdc to 48Vdc
Model No:
- DMX-0500-1000SEL-CPWMD
General:
- USITT-DMX512-A DMX protocol standard
- DMX PWM frequency - 200Hz, constant current switching frequency – 254kHz
- Wide input voltage range of 6Vdc to 48Vdc
- Allow up to 120 drivers to be connected in one single DMX line
- Operating temperature range from 0°C to 50°C, with a maximum temperature of 65°C
- Power Dissipation (loss): 0.45 watt (idle) – no load
@Vin 30Vdc, 25°C 1.85 watt (typical) – typical façade load
6.05 watt (max) – full load
Physical:
- Dimension: 180mm (L) x 43mm (W) x 28mm (H)
- Weight: approx. 210 g
Interface:
- 2 x screw terminal for Power in - 6Vdc to 48Vdc (12 - 22 AWG)
- 4 x screw terminal for LED fixture output (12 - 22 AWG)
- 3 x screw terminal for DMX in (12 - 22 AWG)
- 3 x screw terminal for DMX out (12 - 22 AWG)
Certifications:
- CE compliant - pending
Documentation: